Ubiquiti Networks UAP-AC-3 Guía de usuario descargar pdf (Pagina 16)

Chapter 2: Using the UniFi Controller SoftwareUniFi

Controller User Guide

Ubiquiti Networks, Inc.

Settings > User Groups

Configure user groups on this screen. The default user

group is named Default and has no bandwidth limits.

User Group Settings

Name Displays the name of the user group.

Bandwidth Limit Displays the upload and download

limits.

Actions Click a button to perform the desired action:

• Edit Make changes to the user group settings. Go to the

Create or Edit a User Group section below.

• Delete Delete the user group. (The Default user group

cannot be deleted.)

Create Create a new user group. Go to the Create or Edit a

User Group section below.

Create or Edit a User Group

• Name Enter or edit the name of the user group.

• Bandwidth Limit (Download) Select to limit the

download bandwidth. Enter the maximum in Kbps.

• Bandwidth Limit (Upload) Select to limit the upload

bandwidth. Enter the maximum in Kbps.

• Create Click Create to create a new user group.

• Apply Click Apply to save changes.

• Cancel Click Cancel to discard changes.

See “Configuration” on page 44 for information on

how to assign a user or guest to a user group.

Settings > Controller

Configure the system settings of the UniFi Controller.

UniFi Controller

Controller Hostname/IP Enter the hostname or IP

address of the UniFi Controller.

Note: When alert emails are sent out, the Controller

Hostname/IP will be specified in the Controller URL at

the bottom of every message.

Network Discovery When enabled, this option allows

UniFi to be discoverable via UPnP. This option is disabled

by default.

Mail Server

When enabled, UniFi will send email alerts triggered by

Pending Access Points and Disconnected Access Points.

Specify the administrator email address when you create

an account under Settings> Site Admins.

SMTP Server Select this option to enable emails.

• Enable Mail Server Enter the outgoing (SMTP) mail

server name.

• Port The default is 25. If Secure Sockets Layer (SSL)

is enabled, then the port number will automatically

change to 465.

• Enable SSL You can enable SSL to enhance secure

communications over the Internet.

• Enable Auth. Select this option to enable

authentication.

- username Enter the username required by the

mailserver.

- password Enter the password required by the

mailserver.

• Specify sender address Select this option to specify

the sender email address. Enter the email address that

will appear as the sender of the email alert.

• Test SMTP Server Enter an email address and click

Send to test the mail server setup.

• Apply Click Apply to save changes.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 56 57

Comentarios a estos manuales

Sin comentarios

Ubiquiti Networks UAP-AC-3 Guía de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan Ubiquiti Networks UAP-AC-3