Ubiquiti Networks TS-16-CARRIER Guía de usuario

Rackmount Power over Ethernet Managed SwitchesModel: TS-16-CARRIER

8TOUGHSwitch™ PoE CARRIER Quick Start GuideAccessing the Configuration InterfaceToughSwitch A and B have the same default IP address, 192.168.1.20, so

9Accessing the Configuration Interface4. Change the Static Management IP Address to a unique IP address on the Device tab. Click Save Changes.5. You

10TOUGHSwitch™ PoE CARRIER Quick Start GuideSpecifications8-Port TOUGHSwitch PoE PRO*Power Input 110-120VAC / 210-230VACMax. Power Consumption 150 WPo

11Safety NoticesSafety Notices1. Read, follow, and keep these instructions.2. Heed all warnings.3. Only use attachments/accessories specified by th

12TOUGHSwitch™ PoE CARRIER Quick Start GuideWarranty ConditionsThe above warranty does not apply if the Product:(I) has been modified and/or altered,

13ComplianceLimitation of LiabilityEXCEPT TO THE EXTENT PROHIBITED BY LOCAL LAW, IN NO EVENT WILL UBIQUITI OR ITS SUBSIDIARIES, AFFILIATES OR SUPPLIER

14TOUGHSwitch™ PoE CARRIER Quick Start GuideCE MarkingCE marking on this product represents the product is in compliance with all directives that are

15Declaration of Conformityde collecte indiqués par le gouvernement et les pouvoirs publics des collectivités territoriales. L’élimination et le recyc

16TOUGHSwitch™ PoE CARRIER Quick Start GuideJ050613—720-00024-01Ελληνική [Greek]ΜΕ ΤΗΝ ΠΑΡΟΥΣΑ UBIQUITI NETWORKS ΔΗΛΩΝΕΙ ΟΤΙ UBIQUITI NETWORKS device,

www.ubnt.com© 2012-2013 Ubiquiti Networks, Inc. All rights reserved.Support support.ubnt.comCommunity community.ubnt.comDownloads downloads.ubnt.com

1IntroductionIntroductionThank you for purchasing the Ubiquiti Networks™ TOUGHSwitch™ PoE CARRIER, which is part of the TOUGHSwitch series: Name Model

2TOUGHSwitch™ PoE CARRIER Quick Start GuideHardware OverviewA and B designate the two 8-Port TOUGHSwitch PoE PROs housed in the rack. This may be usef

3Hardware OverviewFront Panel LEDsPower/LinkPoESpeed/Link/ActLED State StatusManagementPower/LinkOff No Power/No LinkAmberAfter bootup, the LED indica

4TOUGHSwitch™ PoE CARRIER Quick Start GuideInstallation Requirements• Phillips and flathead screwdrivers• Standard-sized, 19" wide rack with a

5Hardware Installation2. Attach the TOUGHSwitch PoE CARRIER to the rack using the four #10-32 x 5/8" Phillips Screws. (If the rack has square sl

6TOUGHSwitch™ PoE CARRIER Quick Start Guide4. Connect the other end of each Power Cord to a power outlet.Connecting Ethernet1. Connect an Ethernet c

7Daisy-Chain (Optional)2. Connect Ethernet cables from the Ethernet ports of your devices to the numbered ports of each TOUGHSwitch.Note: PoE is disa